The Con-Kwick Masonry Fastening System includes masonry screws and precision-sized, carbide-tip Con-Kwick Drill Bits. Con-Kwick hardened carbon steel screws form mating threads easily and quickly in brick, block, or structural concrete. This insures a secure, yet easy-to-remove installation.

Con-Kwick Screws are finished with P-K Kote organic coating to provide superior Corrosion Resistance. Con-Kwick is available in serrated Hex Washer and Phillips Flat head styles in both 3/16" and 1/4" diameters.

1. One piece simplicity and economy.
2. Removable yet secure.
3. Location flexibility; close-to-edge, overhead, vertical, horizontal.
4. Patented thread design provides optimum low driving torque.
5. Many contractor and maintenance uses.
6. P-K Kote" organic coating on standards.
7. U.S. Patent #5,061,136.
8. ICBO Approval #4876
9. Hex Washer Con-Kwick features serrations under the head which enhance strip values as well as provide better seating against the attachment fixture.

Fast, Easy Installation

1. Using the special Con-Kwick' Drill Bit* drill pilot hole.
2. Clean hole of excess dust and foreign material.
3. Drive fastener through fixture until seated. Do not overtighten.

WARNING
Wear Eye Protection
*Con-Kwick' Drill Bits are manufactured to closer tolerances than standard ANSI drill bits. Correct hole size is critical to performance. The use of any drill bit other than the Con-Kwick' bit will significantly affect holding power and safety of installation.

Not recommended for use in concrete cured less than 28 days.